Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 3, 2016 17:38:08 GMT -6
ok. i've checked over a few mods, and followed a short write up by 50k on the scs forum, and im still stumped. trying to get the wipers on my truck to actually clear the glass. i think the axis's are pointing in the right directions, and the bone that's supposed to wipe the glass is properly named in the glass.sui any ideas anyone? and what about the glass size numbers in the glass.sui? are they just an x and y measurement?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 5, 2016 2:21:08 GMT -6
anyone?
|
|
|
Post by James60470 on May 5, 2016 6:32:22 GMT -6
What issue are you having? Do you have Fraps or something to record the issue with?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 5, 2016 12:45:10 GMT -6
i explained it. the wipers just aren't wiping the glass. the picture shows the placement of the nodes. and the wiper tip node is named properly in the glass.sui file. i'm just at a loss.
|
|
|
Post by James60470 on May 5, 2016 15:24:32 GMT -6
You need to add some spring tension to the wiper arm so it'll be against the glass.
On a serious note, I'm not entirely sure what's causing that. Maybe look at the stock trucks and see what may be different?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 13, 2016 16:53:24 GMT -6
nothing is different. i need someone whose done custom wipers to chime in here.
|
|